2010 Jaguar XF 5.0

Emergency Brake Reprogram

When the power/ battery is disconnected on the car your emergency brake will not operate and a fault will appear on your instrument cluster.  The fix is to reprogram the emergency brake system.

XF Reset Procedure

1.       First you need to disconnect the battery. I did this by removing the ground(-) cable from the battery and I did it for 15 minutes.

2.       Reconnect the (-) cable to the battery

3.       Start the car

4.       Press on the brake pedal several times to get a hard pedal ( you should not see anything related to the brakes on the instrument cluster)

5.       While still pressing on the brake, apply the electric emergency brake switch

6.       Release the electric emergency brake switch

7.       Release the footbrake

8.       Check instrument cluster for brake related errors.

9.       Apply the emergency brake a few times to make sure you do not have any errors.

 

 

Follow Gus_jagrepair on Twitter

You should follow JagRepair.com on Twitter

See us on Facebook
 

 

Please support JagRepair.com

 

 

Home | Contact Us!

JagRepair.com is designed as an information resource and is not a forum.

All information provided is believed to be correct and it is given in good faith. Users of this information will use good judgment and comply with all the safety rules that apply to operating tools and equipment. JagRepair.com cannot be held responsible if any of the information provided is not correct or does not work for you. Owner of the vehicle accepts responsibility with any and all applications they choose to use.

JAGUAR and its logo are the registered trademarks of Jaguar Land Rover Limited. Jaguar Land Rover Limited is not affiliated with JagRepair.com.

JagRepair.com © 2012 - 2017 by Gus Glikas. All rights reserved.
The JagRepair logos and all proprietary artwork, photos and content are the property of Gus Glikas and may not be reproduced or distributed without expressed written permission.